Z-Wave ZRC-100 Especificaciones descargar pdf (Pagina 53)

Q Can I include all Z-Wave devices from the network by ZRC-

100 and no need to click the PROG button for each device?

A Yes! ZRC-100 provides a useful function which is “Re-scan

Devices” that allows rediscovering all Z-Wave devices from the

network.

Please refer to user manual with below steps:

i) Assume all Z-Wave devices have been added by gateway.

ii) ZRC-100 should act as a secondary controller

[step of B11.1].

iii) Execute the “Re-scan Devices” function [step of C3].

ZRC-100 will rediscover Z-Wave devices from the network,

discovered devices will be re-assigned to their default

categories (Devices, Comforts and Sensors), and names will

be re-assigned with default naming in ascending order.

- This action may take up to 0.5-1 hour depends on how

many devices are in your network, and it will wipe out

all previously stored device names!

- Please make sure batteries are full before proceed!

iv) Now, all Z-Wave devices will appear on the Device, Comfort

and Sensor categories. You can rename your device

individually if needed.

Q Can I use 2 or more ZRC-100 controllers in my house at one

time?

A You can use multiple ZRC-100 around your house by assigning

one remote to be the primary remote and have an additional

secondary controller.

Q What is multi-channel device?

A The multi-channel command class used to control one or more end

points in a given device that supports this command class.

There are several kinds of multi-channel products in the market

such as Z-Wave wall switch / dimmer and power strip. It is able to

control the end-point individually.

z Z-Wave wall switch / dimmer

Multi-Channel Device

End Point 1

Multi-Channel Device

End Point 2

1 2 ... 48 49 50 51 52 53 54 55 56 57 58

Sin comentarios

Z-Wave ZRC-100 Especificaciones Pagina 53