Z-Wave ZRC-100 Especificaciones descargar pdf (Pagina 44)

Re-scan (Rediscover) Devices from network

In most cases, Z-Wave gateway is the primary controller (control

center), all Z-Wave devices will be added / (inclusion) by the Z-Wave

gateway. Normally, it is need to click the PROG button of the Z-Wave

device to add into the network and one by one. The gateway will create

a control page / section to Z-Wave devices. User can control / monitor

Z-Wave devices under the control page.

ZRC-100 can discover all existing Z-Wave devices from the network

and no need to click the PROG button one by one

, discovered devices

will be re-assigned to their default categories (Devices, Comforts and

Sensors), and names will be re-assigned with default naming in

ascending order which is implemented by the function of “Re-scan

Devices”.

To implement this function, your ZRC-100 is needed to follow below

steps:

1) Assume all Z-Wave devices have been added by gateway.

2) ZRC-100 should act as a secondary controller (receive all

network and device information from a primary controller),

please refer to “Learning Mode” section in this manual.

3) Execute the “Re-scan Devices” function with below steps.

Step Setup Key LCD Indication

Press and hold cb keys

simultaneously for 3

seconds under the Home

page.

⇓

Select “Re-scan

Devices” and press

key.

Home

Device >

Scene >

Comfor

OK to Enter

Network Setup

Rediscover N.W. >

Delete Dead Node >

OK to Enter

Re-scan Devices >

Network Setup

Rediscover N.W. >

Delete Dead Node >

OK to Enter

Re-scan Devices >

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 57 58

Comentarios a estos manuales

Sin comentarios

Z-Wave ZRC-100 Especificaciones Pagina 44

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Z-Wave ZRC-100