To delete a thermostat from the remote control:
1. Press and hold SETUP until the screen displays
LIGHT
SETUP
.
2. Scroll until the screen displays
THERMOSTAT, and then press
OK.
The screen displays
ADD.
3. Scroll until the screen displays
DELETE, and then press OK.
The screen displays
SETUP WAITING.
4. Press the button on the thermostat’s Z-Wave interface.
The screen displays
SUCCESS.
Advanced configuration
Some Z-Wave devices provide advanced capabilities available
only with a remote control. Refer to the documentation provided
with the Z-Wave device for available options and specific
parameter and byte values.
To change advanced configuration settings:
1. Press and hold SETUP until the screen displays
LIGHT
SETUP.
2. Scroll until the screen displays
ADV CONFIG, and then press
OK.
The screen displays
PARAM 0.
3. Scroll until the screen displays the proper parameter number
(1 to 255), and then press OK.
The screen displays
NUM BYTES.
4. Scroll until the screen displays the proper number of bytes (1,
2, or 4), and then press OK.
5. Press the button on the device.
The screen displays
SUCCESS.
Recovering network information
The recovery function is used to rebuild the routing table within
the remote control. This table identifies which Z-Wave devices can
communicate with other Z-Wave devices on the network and
helps ensure that commands are transmitted and repeated
through the most efficient route to your destination device.
To have your remote control recover network information:
1. Press and hold SETUP until the screen displays
LIGHT
SETUP
.
2. Scroll until the screen displays
NETWORK, and then press OK.
The screen displays RESET.
3. Scroll until the screen displays
RECOVERY, and then press
OK.
When the screen displays
COMPLETE, you have successfully
recovered network information.
Interoperability with Z-Wave devices
A Z-Wave network can integrate devices of various classes.
Although every Z-wave certified product is designed to work with
all other Z-Wave certified products, the remote control includes
the appropriate device classifications in order to control non-
lighting Z-Wave devices.
Specifications
Operating voltage 4.5 V
Battery type AAA heavy duty or Alkaline
2.9 V min., 4.5 V nom., 4.95 V max.
Low battery indication 2.4 V min., 2.8 V max.
Standby current 120 uA max.
Operating current 19 mA min., 27 mA nom., 50 mA max.
Range Up to 100 feet line of sight between the
wireless controller and the closest
Z-Wave receiver module
Operating temperature 32 to 122ºF (0 to 50ºC)
Storage temperature -20 to 140ºF (-20 to 60ºC)
For indoor use only
FCC
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any
interference, including interference that may cause undesired
operation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user should:
• Reorient or relocate the TV or radio antenna.
• Increase the separation between the device and receiver.
Any changes or modification to the equipment without express
consent will void the user’s right to operate this equipment.
FCC ID: MG345601
IC: 6924A-45601
Model: 45601
Contact information
For contact information see our Web site: www.gesecurity.com.
8 of 8 P/N 1069507 • REV A • ISS 18NOV09
(56 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales